Skip to main content

Install a PCIe adapter (Riser)

Use this information to install a PCIe adapter to the riser.

About this task

Attention
  • Read the following section(s) to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Note

  • GPU adapters are only supported on servers with redundant power supply.

Procedure

  1. Connect all cables to the adapter.
  2. Install the bracket to the PCIe adapter.
  3. Install the PCIe adapter.
    Note

    Ensure that you observe the installation rules and sequence in Technical rules for PCIe slots.

    Figure 1. PCIe adapter installation
    PCIe adapter installation
    Note

    • For the detail connectors on the PCIe riser card, see PCIe riser assembly.

    • Install one adapter at a time, do not insert two adapters to the riser card at the same time.

    1. If fillers are installed on the rear side of the riser cage, remove them.
    2. Align and insert the PCIe adapter assembly into the slot on the PCIe riser. Make sure you install the PCIe adapter into the correct slot.
After you finish

  1. Install the PCIe riser assembly. See Install the PCIe riser assembly.

  2. Install the top cover. See Install the top cover.

  3. If necessary, configure the RAID array using the Setup utility configuration.

  4. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube