Skip to main content

Install the backplane for eight 2.5-inch hot-swap drives

Use this information to install the backplane for eight 2.5-inch hot-swap drives.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening

Before installing the backplane, touch the static-protective package that contains the new backplane to any unpainted surface on the outside of the server. Then, take the new backplane out of the package and place it on a static-protective surface.

To install the backplane, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 1. Installation of backplane for eight 2.5-inch hot-swap drives
Installation of backplane for eight 2.5-inch hot-swap drives

  1. Align the two pins 1 on the backplane with the corresponding holes 2 in the chassis.
  2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the backplane is fully seated in place.
After installing the backplane:

  1. Connect the cables to the backplane. See Backplane for eight 2.5-inch hot-swap drives.

  2. Reinstall all the drives and drive fillers into the drive bays. See Install a hot-swap drive.

  3. Complete the parts replacement. See Complete the parts replacement.