Skip to main content

Install the PCIe riser-card assembly

Use this procedure to install the PCIe riser-card assembly.

Before installing the PCIe riser-card assembly:
  1. Read the safety information and installation guidelines (see Safety and Installation Guidelines).

  2. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

  3. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system board.
    Figure 1. Removing USB 3.0 connector vertically

To install the PCIe riser-card assembly, complete the following steps:

  1. Assemble the PCIe riser-card assembly:
    1. Align the bottom of the PCIe riser-card to the slot, and rotate the top to fit it into the slot on the riser-cage; then, move the PCIe riser-card slightly to fit the holes into the pins.
      Figure 2. PCIe riser-card assembly


    2. Install the PCIe riser-card to the riser-cage with screws.
      Figure 3. PCIe riser-card assembly


  2. Align the PCIe riser-card assembly with the connector on the system board; then, push it in until it clicks in place.
    Figure 4. PCIe riser-card assembly installation


  3. Reconnect all the cables disconnected previously.

After installing the PCIe riser-card assembly, complete the following steps:

  1. Reinstall the top cover (see Install the top cover).

  2. Reconnect the power cords and any cables that you removed.

  3. Install the server in the rack.

  4. Power on the server and any peripheral devices.

Demo video

Watch the procedure on YouTube