Skip to main content

Install the operator panel tray assembly

Use this procedure to install the operator panel tray assembly.

Before installing the operator panel tray assembly:

  1. Read the safety information and installation guidelines (see Safety and Installation Guidelines).

To install the operator panel tray assembly, complete the following steps:

  1. Align the top and bottom of the operator panel tray assembly with the slot in the front of the server, insert the tray assembly into place and fasten the screw to secure it.
    Figure 1. Operator panel tray assembly installation

  2. Connect the front operator panel cable and USB cables to the system board.
    Figure 2. USB 2.0 cable and front operator panel cable

    Table 1. USB 2.0 cable and front operator panel cable
    1 USB 2.0 cable2 Front operator panel cable

After installing the operator panel tray assembly, complete the following steps:

  1. Reconnect the USB 3.0 cable of operator panel tray assembly vertically to the system board.
    Figure 3. Installing USB 3.0 connector vertically

    Route the USB 3.0 cable in the cable guide and away from the PCIe slots area (marked in gray).
    Figure 4. Routing USB 3.0 cable

    1 USB 3.0 connector

  2. Install the PCIe expansion tray (see Install the PCIe expansion tray).

  3. Install the chassis air baffle (see Install the chassis air baffle).

  4. Install the top cover (see Install the top cover).

  5. Reconnect the power cords and any cables that you removed.

  6. If the server is installed in a rack, reinstall the server into the rack.

  7. Power on the server and any peripheral devices.

Demo video

Watch the procedure on YouTube