Skip to main content

Install an M.2 drive in the M.2 backplane

Use this procedure to install an M.2 drive in the M.2 backplane.

Before installing an M.2 drive in the M.2 backplane:
  1. Read the safety information and installation guidelines (see Safety and Installation Guidelines).

  2. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

To install an M.2 drive in the M.2 backplane, complete the following steps:

Note
  • Some M.2 backplanes support two identical M.2 drives. When two drives are installed, align and support both drives when sliding the retainer forward to secure the drives.

  • Install the M.2 drive in slot 0 first.

Figure 1. M.2 drive slot

Table 1. M.2 drive slot
1 Slot 02 Slot 1
  1. Locate the connector on each side of the M.2 backplane.
  2. Insert the M.2 drive at an angle (approximately 30 degrees) into the connector and rotate it until the notch catches on the lip of the retainer; then, slide the retainer forward (toward the connector) to secure the M.2 drive in the M.2 backplane.
    Figure 2. M.2 drive installation

    Attention
    When sliding the retainer forward, make sure the two nubs on the retainer enter the small holes on the M.2 backplane. Once they enter the holes, you will hear a soft “click” sound.
    Figure 3. M.2 drive installation with the retainers in place

After installing an M.2 drive in the M.2 backplane, see Install the M.2 backplane to complete installation.

Demo video

Watch the procedure on YouTube