Skip to main content

Clear storage array recovery mode

The clear storageArray recoveryMode command forces a storage array to exit recovery mode.

Supported Arrays​

This command applies to an individual DE2000H, DE4000H, DE4000F, DE6000H, or DE6000F storage array.

Roles​

To execute this command on an storage array, you must have the Storage Admin role.

Syntax​

clear storageArray recoveryMode

Parameters​

None.

Notes​

Note
Recovery mode is entered during start-of-day operations when the system configuration is cleared and a valid on board backup is available. This mode is exited by either restoring the system configuration from a backup location, or by clearing the existing on board backups. While recovery mode is in force, a needs attention condition is raised and the Recovery Guru is available from the user interface. However, the system configuration is empty during recovery mode.
Attention
If you want to return the storage array to a previous configuration, you must restore the configuration from the backup before clearing recovery mode. You must perform validation checks or check with technical support to make sure that the restore was successful. After determining that the restore was successful, recovery mode can be cleared.