Array Configuration

Set storage array to enable or disable cache mirror data assurance check
The set storageArray cacheMirrorDataAssuranceCheckEnable command allows you to enable or disable the cache mirror data assurance check.
Show storage array cache mirror data assurance check enable
The show storageArray cacheMirrorDataAssuranceCheckEnable command returns the enablement status of the cache mirror data assurance check feature.
Controller commands
Controller health image commands
Create host port
The create hostPort command creates a new host port identification on a host bus adapter (HBA).
Create initiator
The create initiator command creates the initiator object.
Delete initiator
The delete initiator command deletes the initiator object.
Set initiator
The set initiator command updates the initiator object.
Reset storage array host port statistics baseline
The reset storageArray hostPortStatisticsBaseline command resets the storage array host port statistics baseline.
Save storage array host port statistics
The save storageArray hostPortStatistics command saves the storage array host port statistics.
Set controller host port properties
The set controller hostPort command changes the network properties for the following types of host ports: iSCSI and NVMe over RoCE. Property changes include IPv4 and IPv6 properties, port speed, and maximum frame payload.
Set target properties
The set target command changes the properties for an iSCSI target, including authentication method and alias name.
Show unconfigured initiators
The show storageArray unconfiguredInitiators command returns a list of initiators that have been detected by the storage array but are not yet configured into the storage array topology.
Drive commands
Feature management commands
Input output controller (IOC) dump commands
Misbehaving drive (MBD) commands
Offloaded data transfer (ODX) commands
Repository volume analysis commands
Session commands
Storage array commands
Tray commands
Uncategorized commands

Give documentation feedback