Skip to main content

Network Settings

Attention
Clicking “Save Network Settings” at the bottom of this page is required to save changes on this page and subpage.
Table 1. Network Settings
ItemOptionsDescription
Network Interface Port

  • Dedicated (Default)

  • Shared

Select System Management Network Interface Port.

Shared NIC on

OCP Card

Select shared NIC port.

Note
This feature appears only when Network Interface Port is set to [Shared].
Fail-Over Rule

  • None (Default)

  • Failover to shared (Optional Card ML2)

  • Failover to shared (Optional Card PHY)

  • Failover to shared (Onboard Port)

Control the fail-over types allowed.

Note
This feature appears only when Network Interface Port is set to [Dedicated].
Network Setting

  • Synchronization (Default)

  • Independence

The feature is selectable only when Fail-Over Rule is enabled to onboard port or optional card.

Burned-in MAC Address

N/A

Display MAC addresses from the network interface controller.

Hostname

N/A

Change host name. The length must be within 1 to 63 characters.

DHCP Control

  • Static IP

  • DHCP Enabled

  • DHCP with Fallback (Default)

Configure DHCP Control or configure a staic IP address manually.

Fallback uses static IP address if DHCP fails.

Selects [Static IP] to enter IPV4 address manually.

IP Address

x.x.x.x

Enter IP Address in dotted-decimal notation.

Subnet Mask

x.x.x.x

Enter Subnet Mask in dotted-decimal notation.

Default Gateway

x.x.x.x

Enter Default Gateway in dotted-decimal notation.

IPv6

  • Enabled (Default)

  • Disabled

Enable or disable IPv6 support on management port.

Note
This feature is unable to reset to default value by using the load default in Setup.
Local Link Address

N/A

Display local link address.

VLAN Support

  • Enabled

  • Disabled (Default)

Enable or disable VLAN Support to specify the 802.1q VLAN ID on the management port network device.

Note
This feature is unable to reset to default value by using the load default in Setup.
VLAN ID

1

VLAN ID Range is 1 to 4094.

Note
This feature appears only when VLAN Support is enabled.
Advanced Settings for BMC Ethernet

N/A

Provide advanced settings for BMC Ethernet.

Save Network Settings

N/A

Save changes in BMC.