Skip to main content

Network Settings

Attention
Must click the “Save Network Settings” at the bottom of this page to save any change on this page and its subpage.
Table 1. Network Settings
ItemOptionsDescription
Network Interface Port

  • Dedicated

  • Shared

Select the System Management Network Interface Port.

Shared NIC on

OCP Card

Select the shared NIC port.

Fail-Over Rule

  • None

  • Failover to shared (Optional Card ML2)

  • Failover to shared (Optional Card PHY)

  • Failover to shared (Onboard Port)

Setting to control Fail-Over types allowed.

Network Setting

  • Synchronization

  • Independence

The item will be selectable when Fail-Over Rule enabled to onboard port or optional card.

Setup the share mode network settings after changing "Synchronization" to "Independence" in nic failover mode.

Burned-in MAC Address

Unknown

 
Hostname

Unknown

Change the host name. The new name should be within 1 to 63 characters.

 
DHCP Control

  • Static IP

  • DHCP Enabled

  • DHCP with Fallback

Configure DHCP Control or manually configure a static IP address.

Fallback will use static IP address if DHCP fails.

Fallback will use static IP address if DHCP fails.

IP Address

x.x.x.x

Enter IP Address in dotted-decimal notation.
Note

Press <ESC> to return to Setup Utility > Invalid IP address! > ERROR > Invalid Input Range > Ok

Subnet Mask

x.x.x.x

Enter Subnet Mask in dotted-decimal notation.
Note

Press <ESC> to return to Setup Utility > Invalid Subnet Mask! > ERROR > Invalid Input Range > Ok

Press <ESC> to return to Setup Utility
Default Gateway

x.x.x.x

Enter Default Gateway in dotted-decimal notation.
Note

Invalid Gateway! > ERROR > Invalid Input Range > Ok

 
IPv6

  • Enabled

  • Disabled

Enable/disable IPv6 support on management port.

Local Link Address

Unknown

 
 
VLAN Support

  • Enabled

  • Disabled

Enable VLAN Support to specify the 802.1q VLAN ID on the management port network device.

VLAN ID

1

VLAN ID Range is 1 to 4094.

Note

ERROR > Invalid Input Range > Ok

 
Advanced Settings for BMC Ethernet

N/A

Advanced Setting for BMC Ethernet.

Save Network Settings

N/A

Commit the changes to BMC. Please allow a few minutes for the changes to take effect.
Note

Network Settings have been saved successfully > Please allow a few minutes for the changes to take effect > Press <Enter> to Continue > Press <ESC> to return to Setup Utility > BMC Error – Cannot Save Network Settings!