Skip to main content

Using the embedded hypervisor

The VMware ESXi embedded hypervisor software is available on the optional Lenovo USB flash device with embedded hypervisor.

The USB flash device can be installed in the USB connector near PCI-e slot 1 on the system board. Hypervisor is virtualization software that enables multiple operating systems to run on a host system at the same time. The USB flash device is required to activate the hypervisor functions.

To start using the embedded hypervisor functions, you must add the USB flash device to the startup sequence in the Setup utility.

To add the USB flash device to the startup sequence, complete the following steps:

  1. Turn on the server.
    Note
    Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes active.
  2. When the prompt <F1> Setup is displayed, press F1.
  3. From the Setup utility main menu, select Boot Manager.
  4. Select Add Boot Option; then, select USB Storage. Press Enter, and then select Esc.
  5. Select Change Boot Order and then select Commit Changes; then, press Enter.
  6. Select Save Settings and then select Exit Setup.

If the embedded hypervisor flash device image becomes corrupt, you can use the VMware Recovery CD that comes with the system to recover the flash device image. To recover the flash device image, complete the following steps:

  1. Turn on the server.
    Note
    Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes active.
  2. Insert the VMware Recovery CD into the CD or DVD drive.
  3. Follow the instructions on the screen.

For additional information and instructions, see the VMware ESXi Server 31 Embedded Setup Guide at the VMware vSphere Installation and Setup Guide website.