Skip to main content

Solving undetermined problems

If Dynamic System Analysis (DSA) cannot diagnose the failure or if the server is inoperative, use the information in this section to solve the undetermined problems.

If you suspect that a software problem is causing failures (continuous or intermittent), see Power problems.

Corrupted data in CMOS memory or corrupted UEFI firmware can cause undetermined problems. To reset the CMOS data, use the CMOS jumper to clear the CMOS memory and override the power-on password; see System-board jumpers. If you suspect that the UEFI firmware is corrupted, see Recovering the server firmware (UEFI update failure).

If the power supplies are working correctly, complete the following steps:

  1. Turn off the server.
  2. Make sure that the server cover is closed and latched correctly.
  3. Make sure that the server top cover/power cut-off switch cable is connected correctly.
  4. Make sure that the server is cabled correctly.
  5. Remove or disconnect the following devices, one at a time, until you find the failure. Turn on the server and reconfigure it each time.
    • Any external devices.
    • Surge-suppressor device (on the server).
    • Printer, mouse, and non-IBM devices.
    • Each adapter.
    • Hard disk drives.
    • Memory modules. The minimum configuration requirement is 2 GB DIMM in slot 1 when one microprocessor is installed in the server.
  6. Turn on the server.

If the problem is solved when you remove an adapter from the server but the problem recurs when you reinstall the same adapter, suspect the adapter; if the problem recurs when you replace the adapter with a different one, suspect the riser card.

If you suspect a networking problem and the server passes all the system tests, suspect a network cabling problem that is external to the server.