Skip to main content

Cabling SAS/SATA ServeRAID Controller

Use this information to cable the SAS/SATA ServeRAID controller.

The following illustrations show the internal routing and connectors for the SAS/SATA signal cables.

Note
  1. To connect the SAS/SATA signal cables, make sure that you first connect the signal cable, and then the power cable and configuration cable.
  2. To disconnect the SAS/SATA signal cables, make sure that you first disconnect the power cable, and then the signal cable and configuration cable.
Figure 1. ServeRAID-H1110 cable connection
ServeRAID-H1110 cable connection
Figure 2. ServeRAID-M1115 cable connection
ServeRAID-M1115 cable connection
Figure 3. ServeRAID-M5110 cable connection
ServeRAID-M5110 cable connection