跳到主要内容

264-905-000 : Tape Test Failed

Tape Test Failed

Severity​

Error

Serviceable​

Yes

Recoverable​

No

Automatically Notify Support​

No

User Response​

Complete the following steps:

  1. If the system has stopped responding, turn off and restart the system.
  2. Check the system firmware level and upgrade if necessary. The installed firmware level can be found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
  3. Run the test again.
  4. If the system has stopped responding, turn off and restart the system.
  5. Make sure that the drive firmware is at the latest level.
  6. Run the test again.
  7. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.