Skip to main content

dns command errors

This topic lists error messages for the dns command.

See Common errors for a list of error messages that apply to all commands. See dns command for information about command syntax and examples of command use.

Table 1. dns command errors. The error table is a multi-row, two-column table where each row describes a CMM CLI command error: column one lists the error reported by the command-line interface and column two describes what the error means.
Error messageDefinition
-on and -off cannot both be used in the same command.A user tries to enable and disable DNS in the same command.
At least one address is required to enable DNS.A user tries to enable DNS without configuring at least one address.
Configuring DNS failedAn error occurs while configuring DNS.
Disabling DNS failedAn error occurs while disabling DNS.
Enabling DNS failedAn error occurs while enabling DNS.
Getting DNS configuration failedAn error occurs while retrieving DNS information.
IPv6 configuration changes will not take effect until IPv6 is enabled.A user attempts to configure the IPv6 DNS settings while IPv6 is disabled.
Reading status of DNS failed.An error occurs while the CMM is reading the DNS state.