Skip to main content

Front view

The following illustrations show the controls, LEDs, and connectors on the front of your server model.

Figure 1. Front view HX3510-G eight 2.5-inch-drive configuration

Figure 2. Front view HX7510 twenty-four 2.5-inch-drive configuration

Figure 3. Front view HX5510 and HX5510-C eight 3.5-inch-drive configuration

  • Rack release latches: Press the latches on each front side of the server to slide the server out from the rack enclosure.

  • Hard disk drive activity LEDs: These green LEDs are on all hot swap drives.

    • When this LED is flashing, it indicates that the drive is actively reading or writing data.

    • For SAS and SATA drives, this LED is off when the drive is powered but not active.

  • Hard disk drive status LEDs: This LED is used on hot-swap SAS or SATA hard disk drives. When this LED is lit, it indicates that the drive has failed.
  • Operator information panel: This panel contains controls and LEDs that provide information about the status of the server. For information about the controls and LEDs on the operator information panel, see Operator information panel.
  • USB connectors: Connect a USB device, such as a USB mouse or keyboard to any of these connectors.