Skip to main content

Replacing the boot media

You locate the failed boot media in the controller module by removing the air duct on the controller module before you can replace the boot media.

You need a #1 magnetic Phillips head screw driver to remove the screw that holds the boot media in-place. Due to the space constraints within the controller module, you should also have a magnet to transfer the screw on to so that you do not loose it.

A video for this task is available at:
  1. Locate the impaired boot media from the controller module.
  2. Use either your thumb or a Phillips head screwdriver to loosen the screw on the right of the boot media until the device comes free.
  3. Gently lift the boot media directly out of the socket.
  4. Align the replacement boot media into place in the impaired controller.
  5. Use the screwdriver or your thumb to tighten the screw on the boot media.