Skip to main content

Install the drip sensor assembly

Use this information to install the drip sensor assembly.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. Align the drip sensor assembly with the enclosure and slide it into place.
    Figure 1. Drip sensor assembly installation
    Drip sensor assembly installation
  2. Install the lower EMC shield.
    1. Align the bottom of the EMC shield with the enclosure.
    2. Rotate the top of the EMC shield inwards until it is secured in place.
    Figure 2. Lower EMC shield installation
    Lower EMC shield installation
  3. Install manifold retention bracket that is retaining the manifold (top enclosure position only).
    Figure 3. Retention bracket installation
    Retention bracket installation

After you finish

Install the EMC shields. See Install an EMC shield.

Demo video

Watch the procedure on YouTube