Skip to main content

SD650-N V3 high-density server

Refer to this section to for a brief introduction on the DW612S enclosure configuration with six SD650-N V3 server.

For more information on SD650-N V3 high-density server, see SD650-N V3 User Guide.

Attention

Start with slot 1 when installing trays into the DW612S enclosure.

Figure 1. DW612S enclosure with six SD650-N V3 server
DW612S enclosure with six SD650-N V3 server
Note

  • The illustration in this section is for reference only.

  • The slot numbers are indicated on both sides of the enclosure.

Table 1. DW612S enclosure with six SD665-N V3 server
Number of SD665-N V3 serverPower supply configurations
Six
  • Supports nine hot-swap 2600W AC power supplies.

    • Sine-wave input (50-60 Hz) required

    • Input voltage for 2600W power supplies:

      • 200-208 Vac, 240 Vdc (output up to 2400W only)

      • 208-240 Vac, 240 Vdc

    • Nine power supplies: 8+1 without oversubscription

  • Supports three hot-swap DWC 7200W power supplies.

    • Input voltage:

      • 200-208 Vac (work as 6900W)

      • 220-240 Vac, 240 Vdc (work as 7200W)

    • Three DWC PSUs: work as 8+1 without oversubscription

CAUTION

Power supplies and redundant power supplies in the enclosure must be with the same brand, power rating, wattage or efficiency level.

Mixing PSUs manufactured by different vendors is not supported.

Note
Refer to SMM2 web interface for more details of solution power status.