Removing a low-profile adapter

Use these instructions to remove an adapter from the PCIe Expansion Node low-profile PCIe riser.

Before you remove an adapter from the PCIe Expansion Node low-profile PCIe riser, complete the following steps:

1. Read Safety and Installation guidelines.
2. If you are not replacing the adapter, you must have a filler to install in the empty slot. Obtain the correct slot filler before continuing.
3. If the PCIe Expansion Node is installed in a Flex System Enterprise Chassis, remove it (see Removing a PCIe Expansion Node and attached compute node host for instructions).
4. Carefully lay the PCIe Expansion Node on a flat, static-protective surface with the right side of the unit oriented toward you.
5. Remove the PCIe Expansion Node cover (see Removing the cover for instructions).

Statement 21

CAUTION

Hazardous energy is present when the blade is connected to the power source. Always replace the blade cover before installing the blade.

To remove an adapter from the low-profile PCIe riser, complete the following steps.

1. Grasp the low-profile PCIe riser by the blue touch points and pull the riser straight up to disconnect the riser from the system board connector; then, lift the low-profile PCIe riser out of the PCIe Expansion Node.
   
   
   
2. Carefully lay the low-profile PCIe riser on it's right side on a flat, static-protective surface with the adapter slots facing up.
   Note

   The low-profile PCIe riser has two connectors for PCIe adapter cards. The lower connector is for adapter slot 3 and the upper connector is for adapter slot 4.
3. Pull the adapter out of the slot and remove it from the riser.
   Important

   Each adapter slot must have either an adapter or a filler installed. If the adapter will not be immediately replaced, install a filler in the adapter slot.