Skip to main content

Installing and removing a 1U device in/from the side pocket

See this topic to learn how to install or remove a 1U PDU or console switch in the side pocket.

Install a 1U device into the side pocket​

About this task

Warning
Make sure to complete all the required cable connection and device setup before installing baying kits to the cabinets, as these tasks will be hard to operate afterwards.

Procedure

  1. Remove the side cover next to the side pocket (see Remove a side cover ).
  2. Refer to the document that comes with the device, and install the mounting brackets if necessary.
  3. Install the device.
    Figure 1. Installing a 1U PDU or console switch

    • Slide the device all the way into the side pocket.
    • Secure the device with four M6 screws.
  4. Complete all the required cable connection and setup of the device. Refer to the document that comes with the device for details.
    Warning
    • Make sure to complete all the required cable connection and device setup before installing baying kits to the cabinets, as these tasks will be hard to operate afterwards.

    • It is advised to complete all the cable connection and setup task for the device before installing the side cover back.

  5. Install the side cover back (see Install a side cover).

Remove a 1U device from the side pocket​

Remove the device.
Figure 2. Removing a 1U PDU or console switch

  • Remove the four M6 screws.
  • Slide the device all the way out from the side pocket.