Skip to main content

Installing an IOM

When you install an IOM, you slide the IOM into the shelf, close the cam handle to secure the IOM in place, and reconnect the SAS cables.

  • You have an ESD wristband, or you have taken other antistatic precautions.

  • You have the replacement IOM.

  1. With the cam handle in the open position, insert the new IOM into the disk shelf, firmly pushing until the IOM meets the midplane.
    Attention
    Do not use excessive force when sliding the IOM into the disk shelf; you might damage the connectors.
  2. Close the cam handle so that the latch clicks into the locked position and the IOM is fully seated.
  3. Reconnect the cables.

    SAS cable connectors are keyed. When inserting the connectors make sure each connector clicks into place.

    Attention
    Never force the connectors into the ports; you might damage the cables, the ports, or both.