Commands for checking and monitoring the MetroCluster configuration
There are specific ONTAP commands for monitoring the MetroCluster configuration and checking MetroCluster operations.
Commands for checking MetroCluster operations
| If you want to... | Use this command... |
|---|---|
| Perform a check of the MetroCluster operations. Note This command should not be used as the only command for pre-DR operation system validation. | metrocluster check run |
| View the results of the last check on MetroCluster operations. | metrocluster show |
| View results of check on configuration replication between the sites. | metrocluster check config-replication show metrocluster check config-replication show-aggregate-eligibility |
| View results of check on node configuration. | metrocluster check node show |
| View results of check on aggregate configuration. | metrocluster check aggregate show |
| View the LIF placement failures in the MetroCluster configuration. | metrocluster check lif show |
Commands for monitoring the MetroCluster interconnect
| If you want to... | Use this command... |
|---|---|
| Display the HA and DR mirroring status and information for the MetroCluster nodes in the cluster. | metrocluster interconnect mirror show |
Commands for monitoring MetroCluster SVMs
| If you want to... | Use this command... |
|---|---|
| View all SVMs in both sites in the MetroCluster configuration. | metrocluster vserver show |
Give documentation feedback