Skip to main content

Docs

ThinkSystem
ThinkEdge
System x
Option

Storage Software

ThinkAgile
Water Cooling Solution

English
简体中文

Docs

Filter by title

MetroCluster Service and Expansion Guide
Deciding whether to use this guide
Where to find procedures for MetroCluster maintenance tasks
MetroCluster failure and recovery scenarios
Performing FC-to-SAS bridge maintenance
Performing FC switch maintenance and replacement
Performing IP switch maintenance and replacement
Adding, removing, or changing ISL ports nondisruptively
Identifying storage in a MetroCluster IP configuration
Hot-adding storage to a MetroCluster FC configuration
Hot-removing storage from a MetroCluster FC configuration
Replacing a shelf nondisruptively in a fabric-attached MetroCluster configuration
When to migrate root volumes to a new destination
Moving a metadata volume in MetroCluster configurations
Renaming a cluster in MetroCluster configurations
Powering off and powering on a data center
Powering off an entire MetroCluster IP configuration
Powering off an entire MetroCluster FC configuration
Reconfiguring the FC switch layout
Port assignments for FC switches
- Port assignments for systems using two initiator ports
- Port assignments for FC switches
Where to find additional information
Contacting Support
Notices

Port assignments for FC switches

Port assignments for FC switches

You need to verify that you are using the specified port assignments when you cable the FC switches.

Port assignments for systems using two initiator ports
You can configure DM7000H and AFA DM7000F systems using a single initiator port for each fabric and two initiator ports for each controller.
Port assignments for FC switches
You need to verify that you are using the specified port assignments when you cable the FC switches.

Give documentation feedback

Verifying switchover, healing, and switchback

Port assignments for systems using two initiator ports

© 2024 Lenovo. All rights reserved. Privacy Policy | Terms of Use