Skip to main content

Installing the USB flash drive

Use this information to install the USB flash drive.

Before you install the USB flash drive, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the fan power control is installed in the NeXtScale n1200 Enclosure, remove it (see Removing the fan power control).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

This component can be installed as an optional device or as a CRU. The installation procedure is the same for the optional device and the CRU.

To install the USB flash drive, complete the following steps.

Figure 1. Installing USB flash drive
graphic illustrating USB flash drive removal

  1. Locate the USB connector on the fan power control.
  2. Push the USB flash drive into the connector.
After you install the USB flash drive, Install the fan power control into the chassis (see Replacing an fan power control).