Skip to main content

Disassemble the node for recycle

Follow instructions in this section to disassemble the node before recycling the node tray.

About this task

Attention
  1. Power off the node (see Power off the node); then, disconnect all external cables from the node.
  2. Remove the node from the chassis (see Remove a node from the chassis); then, carefully lay the node on a flat, static-protective surface, orienting the node with the front toward you.
  3. Remove the top cover (see Remove the top cover).
  4. Remove the drive backplane (see Remove the drive backplane).
  5. Remove the firmware and RoT security module (see Remove the firmware and RoT security module).
  6. Remove the processor and heat sink (see Remove the processor and heat sink).
  7. Remove all the memory modules (see Remove a memory module).
  8. If necessary, remove the M.2 drives (see Remove an M.2 drive).
  9. Remove the microSD card (see Remove the MicroSD card).
  10. Disconnect all the fan cables from the system board; then, remove all the fans from the fan cage (see Remove a fan).
  11. If the PCIe riser assembly is installed, remove it from the node and disconnect the PCIe cables from the system board (see Remove the PCIe riser assembly and Internal cable routing).
  12. Remove the power bus bar (see Remove the power bus bar).
  13. Disconnect the power distribution board cables from the system board; then, remove the power distribution board (see Remove the power distribution board).
  14. Remove the rear I/O module (see Remove the rear I/O module).
  15. Remove all the installed cable walls
  16. Disconnect all the cables from the system board.
  17. Remove the system board (see Remove the system board (Trained technician only)).