Skip to main content

Install a MicroSD card

Follow instructions in this section to install a MicroSD card.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

  • Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the node and chassis; then, take the component out of the package and place it on a static-protective surface.

Procedure

  1. Locate the MicroSD socket on the system board.
    Figure 1. Location of the MicroSD socket
    Location of the MicroSD socket
  2. Install the MicroSD card to the system board.
    1. Place the MicroSD card into the socket.
    2. Close the socket lid.
    3. Slide the socket lid to the lock position.
      Figure 2. Installation of a MicroSD card
      MicroSD card installation

After you finish

  1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover (see Install the top cover).
  2. Reinstall the node into the chassis (see Install a node to the chassis).
  3. Make sure that the required power supply units are installed and power cords are connected; then, power on the node (see Install a hot-swap power supply and Power on the node).
  4. Proceed to complete the parts replacement (see Complete the parts replacement).

Demo video

Watch the procedure on YouTube