Skip to main content

Install a power distribution board

Follow instructions in this section to install a power distribution board.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

  • Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the node and chassis; then, take the component out of the package and place it on a static-protective surface.

Procedure

  1. Connect the sideband cable to the power distribution board.
  2. Install the power distribution board.
    1. Align the screws holes on the power distribution board with the screw holes on the node; then, lower and insert the power distribution board into place.
    2. Tighten the five screws to secure the power distribution board to the node.
      Note
      Make sure that the standoffs are securely seated in the holes of the power distribution board.
      Figure 1. Installation of a power distribution board
      Installation of a power distribution board
  3. Connect the power cable to the power distribution board; then, reconnect the power distribution board cables to the system board (see Internal cable routing).

After you finish

  1. Reinstall the power bus bar (see Install a power bus bar).
  2. Reinstall the PCIe riser assembly and reconnect the cables (see Install a PCIe riser assembly and Internal cable routing).
  3. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover (see Install the top cover).
  4. Reinstall the node into the chassis (see Install a node to the chassis).
  5. Make sure that the required power supply units are installed and power cords are connected; then, power on the node (see Install a hot-swap power supply and Power on the node).
  6. Proceed to complete the parts replacement (see Complete the parts replacement).

Demo video

Watch the procedure on YouTube