Thermal sensor cable routing
Follow instructions in this section to install and route the cable for the front thermal sensor cable.
Note
- Depending on the specific configuration, the information in this topic might not apply to your node.
Connections between connectors; 1↔1, 2↔2, 3↔3, ... n↔n
When routing the cables, make sure that all cables are routed appropriately through the corresponding cable guides and cable clips.
- Strictly observe the following instructions to avoid damaging cable sockets on the system board. Any damage to the cable sockets might require replacing the system board.
Connect cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.
- To disconnect cables from the system board, do as follows:
Press and hold all latches, release tabs, or locks on cable connectors to release the cable connectors.
- Remove the cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.NoteThe cable connectors might look different from those in the illustration, but the removal procedure is the same.
Front thermal sensor cable routing
Figure 1. Front thermal sensor cable routing
From (system board) | To (Front thermal sensor) | Cable |
---|---|---|
1 Inlet temperature sensor connector | 1 Front thermal sensor | Thermal sensor cable 1x3 (220 mm) |
Give documentation feedback