Skip to main content

Power supply LED

This topic provides information about various power supply LED status and corresponding action suggestions.

  • The following minimal configuration is required for the node to start:
    • System board
    • Firmware and RoT security module (installed on the system board)
    • One processor
    • One memory module in DIMM slot 6
    • One power supply in PSU slot 1
    • One boot drive, M.2 or 2.5-inch drive, and RAID adapter if configured (If OS is needed by debugging)
    • Four system fans
Figure 1. Power supply LED
Power supply LED
LEDDescription
1 Power supply status
The power supply status LED can be in one of the following states:

  • Green: The power supply is connected to the AC power source and working normally.

  • Off: The power supply is disconnected from the AC power source.

  • Slow blinking green (about one flash every second): The power supply is in PSU standby state with AC present, cold standby state, or always standby state.

  • Amber: The AC power cord is unplugged, AC power lost (with a second power supply in parallel still in AC power input power), or power supply has failed. To resolve the issue, replace the power supply.

  • Slow blinking amber (about one flash every second): Power supply warning events where the power supply continues to operate.