Remove a hot-swap power supply
Use this information to remove a hot-swap power supply.
About this task
To avoid a shock hazard:
- Connect all power cords to a properly wired and grounded electrical outlet/source.
- Connect any equipment that will be attached to this product to properly wired outlets/sources.
- When possible, use one hand only to connect or disconnect signal cables.
- Never turn on any equipment when there is evidence of fire, water, or structural damage.
- The device might have more than one power cord, to remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.
High touch current. Connect to earth before connecting to supply.
- Read the following sections to ensure that you work safely.
Disconnect the power cord from the connector on the back of the power supply.
If only one hot-swap power supply is installed in the solution, you must turn off the solution before removing the power supply.
Procedure
- Press and hold the orange release tab.Figure 1. Hot-swap power supply removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Demo video