Remove the tray cover

Use this information to remove the tray cover.

S014

CAUTION

Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.

S033

CAUTION

Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Before you remove the tray cover:

1. Read the Installation Guidelines to ensure that you work safely.

2. Turn off the corresponding DWC tray that you are going to perform the task on.

3. Remove the tray out of the enclosure (see Remove a DWC tray from the enclosure).

Complete the following steps to remove the tray cover.

1. Press on the release latch and the push point at the same time and slide the cover toward the rear of the DWC tray.
   Figure 1. Tray cover removal
   
   
2. Lift the cover off the DWC tray and set it aside.
   Note

   Service label instructions are located on the underside of each tray cover.