Skip to main content

Remove the M.2 WLAN module

Use this information to remove the M.2 WLAN module.

Before you remove the M.2 WLAN module, complete the following steps:
  1. Read the following sections to ensure that you work safely.

  2. Turn off the server. Disconnect the power cords and all external cables (see Power off the server).

  3. Remove the node from the enclosure if needed (see Remove a node).

  4. Remove a LTE/WLAN Antenna (see Remove a LTE/WLAN Antenna).

  5. Remove the M.2 WLAN/LTE wireless adapter (see Remove the M.2 WLAN/LTE wireless adapter).

Procedure

  1. Remove the M.2 WLAN module cables from the cable clip.
    Figure 1. M.2 WLAN module removal
    M.2 WLAN module removal
  2. Press the module latch. Rotate the M.2 WLAN module up and pull it out from the adapter.
    Figure 2. M.2 WLAN module removal
    M.2 WLAN module removal
  3. Slide the cable holder out from the M.2 WLAN module.
    Figure 3. M.2 WLAN module removal
    M.2 WLAN module removal
  4. Use the screwdriver in the Misc kit to hook the cable as shown, and remove the cable from the M.2 WLAN module. Apply the same method to the main cable and the AUX cable.
    Note
    Carefully to remove the cables, make sure the cable is removed vertically without excessive force.
    Figure 4. M.2 WLAN module removal
    M.2 WLAN module removal
  5. Use screwdriver in the Misc kit to counterclockwise remove the nut and the washer on the rear of the server.
    Note
    Apply the same method to remove both main and AUX cable.
    Figure 5. M.2 WLAN module removal
    M.2 WLAN module removal
    Table 1. M.2 WLAN module removal
    1 M.2 WLAN module cable3 Nut
    2 Washer 

If you are instructed to return the defective component, please package the part to prevent any shipping damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Demo video