Remove the flash power module

Use this information to remove the flash power module on the RAID adapter.

About this task

Attention

Read Safety inspection checklist and Installation Guidelines to ensure that you work safely.
Power off the corresponding compute node that you are going to perform the task on.
Remove the compute node from the chassis. See Remove the compute node from chassis.
Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

Note

This section only applies to RAID adapters that come with a flash power module.

Procedure

Make preparations for your compute node.
1. Remove the compute node cover. See Remove the compute node cover.
2. Remove the RAID adapter. See Remove the RAID adapter.
Remove the flash power module.
1. Press the rear of the flash power module.
2. Slide the flash power module out of its holder on the RAID adapter.
3. Disconnect the flash power module cable on the RAID adapter.
Figure 1. Flash power module removal

Attention
To prevent any damage to the flash power module cable or connector, it is important to first slide out the flash power module. This provides more space for your fingers to better grip the flash power module cable and remove it from the connector.

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube

Give documentation feedback