Install the front I/O assembly

Use this information to install the front I/O assembly.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before installing the front I/O assembly, touch the static-protective package that contains the new front I/O assembly to any unpainted surface on the outside of the server. Then, take new the front I/O assembly out of the package and place it on a static-protective surface.

To install the front I/O assembly, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Table 1. Front I/O assembly installation

Figure 1. Server models with 2.5-inch drive bays

Figure 2. Server models with 3.5-inch drive bays

1. Insert the front I/O assembly into the assembly bay.
2. Install the screws to secure the front I/O assembly in place.
3. Connect the cables of the front I/O assembly to the system board. See Internal cable routing.