Skip to main content

Install the simple-swap drive backplate assembly

Use this information to install the simple-swap drive backplate assembly.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening

Before installing the simple-swap drive backplate assembly, touch the static-protective package that contains the new backplate assembly to any unpainted surface on the outside of the server. Then, take the new backplate assembly out of the package and place it on a static-protective surface.

To install the simple-swap drive backplate assembly, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 1. Simple-swap drive backplate assembly installation
Install the simple-swap drive backplate assembly

  1. Put the backplate assembly under the front I/O assembly cables, align it with the chassis, and lower it into the chassis. Put the backplate assembly into place with it leaning backward slightly so that the three pins 1 on the chassis pass through the three holes 2 in the assembly.
  2. Close the release latches to secure the backplate assembly in place.
After installing the simple-swap drive backplate assembly:

  1. Connect cables of the simple-swap drive backplate assembly to the system board. See Internal cable routing.

  2. Reinstall all the drives and drive fillers that you removed. See Install a simple-swap drive.

  3. Complete the parts replacement. See Complete the parts replacement.