Zum Hauptinhalt springen

Install the RAID flash power module on the air baffle

Use this information to install the RAID flash power module on the air baffle.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Touch the static-protective package that contains the RAID flash power module to any unpainted surface on the outside of the server. Then, take the RAID flash power module out of the package and place it on a static-protective surface.
  2. Install the RAID flash power module on the air baffle.
    Figure 1. Installation of the RAID flash power module on the air baffle
    Installation of the RAID flash power module on the air baffle

    1. Open the retention clip on the holder.
    2. Put the RAID flash power module into the air baffle and press it down to secure it into the air baffle.

After you finish

  1. Install the air baffle on the chassis. See Install the air baffle.

  2. Connect the flash power module to an adapter with the extension cable that comes with the flash power module.

  3. Complete the parts replacement. See Complete the parts replacement.