Skip to main content

Top view

This section contains information on the top view of the server with standard heat sinks or a direct water cooling module (DWCM).

Note

  • The following illustrations show the top view of the server without any air baffle, middle cage, or rear cage installed.

  • The following illustrations show the server rear configuration with three riser assemblies. The server rear configurations vary by server model. For details, see Rear view.

Top view with standard heat sinks​

Figure 1. Top view with standard heat sinks
Front view of the server with typical configuration
Table 1. Component identification (top view with standard heat sinks)

1 Front backplane(s)

2 Intrusion switch

3 System fans

4 Memory modules

5 Processors and heat sinks

6 Riser assemblies

7 System board assembly

8 CFF RAID adapter/expander

Note

The illustration shows the server with CFF adapters which are available only in the 2.5-inch chassis. In some configurations, there might be installed with a RAID flash power module. For details, see Table 1.

Top view with DWCM​

Figure 2. Top view with DWCM
Top view with DWCM
Table 2. Components identification (top view with DWCM)
1Outlet hose2Inlet hose
3Hose holder4Liquid detection sensor module
5Cold plate assembly

6 Riser cage for DWCM