Skip to main content

Remove the system board air baffle and the power interposer

Follow the instructions in this section to remove the system board air baffle and the power interposer.

Note

If the server comes with a processor and memory expansion tray, it doesn’t come with this component

Before removing the system board air baffle, complete the following steps:

  1. Read the safety information and installation guidelines (see Safety and Installation Guidelines).

  2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see Power off the server).

  3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover, or remove the server from the rack.

  4. Remove the top cover (see Remove the top cover).

To remove the system board air baffle, complete the following steps:

  1. Slightly slide power supply 2 out from the power supply bay (see ).
  2. Lift the power interposer from the server, and set it aside.
    Figure 1. Power interposer removal

  3. Lift the system board air baffle from the server, and set it aside.
    Attention
    Air baffle is required for airflow that creates proper cooling. Make sure proper air baffles for system configuration is installed before the power is turned on.
    Figure 2. System board air baffle removal

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.