Parts list
Identify each of the components that is available for your server with the parts list.
Go to Lenovo Data Center Support and navigate to the support page for your server.
Click .
Enter the serial number to view a listing of parts for your server.
It is highly recommended that you check the power summary data for your server using Lenovo Capacity Planner before purchasing any new parts.
T1: Tier 1 customer replaceable unit (CRU). Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
T2: Tier 2 customer replaceable unit (CRU). You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
F: Field replaceable unit (FRU). FRUs must be installed only by trained service technicians.
C: Consumable and Structural parts. Purchase and replacement of consumable and structural parts (components, such as a filler or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.
| Index | Description | Type |
|---|---|---|
For more information about ordering parts:
| ||
| 1 | Fixed power supply unit | T2 |
| 2 | CRPS hot-swap power supply unit | T2 |
| 3 | Power distribution board for hot-swap power supplies | T2 |
| 4 | CRPS hot-swap power supply filler | C |
| 5 | 5.25-inch optical disk drive | T1 |
| 6 | 5.25-inch LTO/RDX tape drive | T1 |
| 7 | Processor | F |
| 8 | System board | F |
| 9 | Heat sink and fan | F |
| 10 | Front system fan | T1 |
| 11 | Front I/O module | T2 |
| 12 | Drive cage cover | T1 |
| 13 | Drive cage filler | T1 |
| 14 | 2.5-inch drive cage | T1 |
| 15 | Firmware and RoT security module | F |
| 16 | 2.5-inch drive filler | C |
| 17 | 3.5-inch drive filler | C |
| 18 | 2.5-inch hot-swap drive | T1 |
| 19 | 3.5-inch simple-swap drive | T1 |
| 20 | 3.5-inch hot-swap drive | T1 |
| 21 | 3.5-inch hot-swap drive backplane | T1 |
| 22 | 3.5-inch simple-swap drive backplate | T1 |
| 23 | 3.5-inch simple-swap drive backplate with ODD | T1 |
| 24 | 3.5-inch drive cage | T1 |
| 25 | 2.5-inch to 3.5-inch drive adapter | T1 |
| 26 | 2.5-inch hot-swap drive backplane | T1 |
| 27 | Front door | T1 |
| 28 | Chassis | T1 |
| 29 | PCIe adapter | T1 |
| 30 | Rear system fan | T1 |
| 31 | RAID flash power module holder | T2 |
| 32 | RAID flash power module | T1 |
| 33 | Memory module | T1 |
| 34 | Intrusion switch | T1 |
| 35 | CMOS battery (CR2032) | C |
| 36 | M.2 drive | T1 |
| 37 | PCIe adapter for M.2 boot adapter | T1 |
| 38 | M.2 boot adapter | T1 |
| 39 | 5.25-inch Optical drive filler cover and optical drive filler | T1 |