Skip to main content

Install the intrusion switch

Use this information to install the intrusion switch.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening

Before installing the intrusion switch, touch the static-protective package that contains the new intrusion switch to any unpainted surface on the outside of the server. Then, take the new intrusion switch out of the package and place them on a static-protective surface.

To install the intrusion switch, complete the following steps:

Watch the procedure
  • A video of this procedure is available at YouTube

  1. Insert the intrusion switch into the chassis and push it in the direction as shown until it is fully seated.
    Figure 1. Intrusion switch installation
    Intrusion switch installation

  2. Connect the cable of the intrusion switch to the intrusion switch connector on the system board. For the location of the intrusion switch connector, refer to System board components.
After installing the intrusion switch:

  1. Install the PCIe adapter retainer. See Install the PCIe adapter retainer.

  2. Complete the parts replacement. See Complete the parts replacement.