Install the system board

Use this information to install the system board.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before installing the system board, touch the static-protective package that contains the new system board to any unpainted surface on the outside of the server. Then, take the new system board out of the package and place it on a static-protective surface.

To install the system board, complete the following steps:

Watch the procedure

• A video of this procedure is available at YouTube

Figure 1. System board installation

1. Gently lower the system board into the chassis. Then, move the system board toward the rear of the server. Ensure that the rear connectors on the new system board are inserted into the corresponding holes in the rear panel.
2. Tighten the thumb screw.
3. Install the eight screws to secure the system board in place.

After installing the system board:

1. Push the power supplies into the bays until they click into place.

2. Install any components that you removed from the failing system board. See the related topics in Hardware replacement procedures.

3. Update the machine type and serial number with new vital product data (VPD). Use the Lenovo XClarity Provisioning Manager to update the machine type and serial number. See Update the machine type and serial number.

4. Enable TPM/TCM. See Enable TPM/TCM.

5. Optionally, enable Secure Boot. See Enable UEFI Secure Boot.