Skip to main content

Server hardware setup

To set up the server, install any options that have been purchased, cable the server, configure and update the firmware, and install the operating system.

  • Server setup checklist
    Use the server setup checklist to ensure that you have performed all tasks that are required to set up your server.
  • Installation guidelines
    Use the installation guidelines to install components in your server.
  • Memory module installation rules and order
    Memory modules must be installed in a specific order based on the memory configuration that you implement on your server.
  • Technical rules
    This topic provides technical rules for the server.
  • Install server hardware options
    This section has instructions for performing initial installation of optional hardware. Each component installation procedure references any tasks that need to be performed to gain access to the component being replaced.
  • Install the tower to rack conversion kit
    This section includes instructions on how to install the tower to rack conversion kit.
  • Install the rail kit
    This section includes instructions on how to install the rail kit.
  • Cable the server
    Attach all external cables to the server. Typically, you will need to connect the server to a power source, to the data network, and to storage. In addition, you will need to connect the server to the management network.
  • Power on the server
    After the server performs a short self-test (power status LED flashes quickly) when connected to input power, it enters a standby state (power status LED flashes once per second).
  • Validate server setup
    After powering up the server, make sure that the LEDs are lit and that they are green.
  • Power off the server
    The server remains in a standby state when it is connected to a power source, allowing the Lenovo XClarity Controller to respond to remote power-on requests. To remove all power from the server (power-on LED off), you must disconnect all power cables.