Power cords

Information about the power cords available for the ThinkAgile CP storage and compute blocks.

Several power cords are available, depending on the country and region where ThinkAgile CP is installed.

To view the power cords that are available for a component:

• Interconnect switch

  1. Go to: Lenovo Data Center Support page (7Y67)

  2. Click Parts

  3. Click Select Commodity and choose Line Cords

• Compute block

  1. Go to: Lenovo Data Center Support page (7X20)

  2. Click Parts

  3. Click Select Commodity and choose Line Cords

• Storage block

  1. Go to: Lenovo Data Center Support page (7Y66)

  2. Click Parts

  3. Click Select Commodity and choose Line Cords

Note

• For your safety, a power cord with a grounded attachment plug is provided to use with this product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.

• Power cords for this product that are used in the United States and Canada are listed by Underwriter's Laboratories (UL) and certified by the Canadian Standards Association (CSA).

• For units intended to operate at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a minimum 18 AWG, type SVT or SJT, three-conductor cord, a maximum of 15 feet (4.6 meters) in length and a parallel blade, grounding-type attachment plug rated 15 amperes, 125 volts.

• For units intended to operate at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet (4.6 meters) in length and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.

• For units intended to operate at 230 volts (outside the U.S.): Use a cord set with a grounding-type attachment plug. The cord set should have the appropriate safety approvals for the country in which you install the equipment.

• Power cords for a specific country or region are usually available only in that country or region.