Skip to main content

Test results for the DSA memory stress test

The following messages can result when you run the DSA memory stress test.

  • 202-000-000 : MemStr Test Passed

    Test Passed.
    Recoverable
    No
    Severity
    Event
    Serviceable
    No
    Automatically notify support
    No
    Related links

  • 202-801-000 : MemStr Test Aborted

    Internal program error.
    Recoverable
    No
    Severity
    Warning
    Serviceable
    Yes
    Automatically notify support
    No
    User Response
    Complete the following steps:
    1. Turn off and restart the system.
    2. Make sure that the DSA Diagnostic code is at the latest level.
    3. Run the test again.
    4. If the system has stopped responding, turn off and restart the system.
    5. Check the system firmware level and upgrade if necessary.
    6. Run the memory diagnostic to identify the specific failing DIMM.
    7. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.
    Related links

  • 202-802-000 : MemStr Test Aborted

    Memory size is insufficient to run the test. At least 1 GB is required.
    Recoverable
    No
    Severity
    Warning
    Serviceable
    Yes
    Automatically notify support
    No
    Related links

  • 202-803-000 : MemStr Test Aborted

    User pressed Ctrl-C.
    Recoverable
    No
    Severity
    Warning
    Serviceable
    Yes
    Automatically notify support
    No
    Related links

  • 202-901-000 : MemStr Test Failed

    Test Failed.
    Recoverable
    No
    Severity
    Error
    Serviceable
    Yes
    Automatically notify support
    No
    User Response
    Complete the following steps:
    1. Execute the standard DSA memory diagnostics to validate all memory.
    2. Make sure that the DSA Diagnostic code is at the latest level.
    3. Turn off the system and disconnect it from power.
    4. Reseat the memory cards and DIMMs.
    5. Reconnect the system to power and turn the system on.
    6. Run the test again.
    7. Execute the standard DSA memory diagnostics to validate all memory.
    8. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.
    Related links

  • 202-902-000 : MemStr Test Failed

    Memory size is insufficient to run the test.
    Recoverable
    No
    Severity
    Error
    Serviceable
    Yes
    Automatically notify support
    No
    User Response
    Complete the following steps:
    1. Ensure that all memory is enabled by checking the "Available System Memory" in the "Resource Utilization" section of the DSA Diagnostic Event log.
    2. If necessary, access the Configuration/Setup Utility program by pressing F1 during system boot and enable all memory.
    3. Make sure that the DSA Diagnostic code is at the latest level.
    4. Run the test again.
    5. Execute the standard DSA memory diagnostics to validate all memory.
    6. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.
    Related links