Skip to main content

Cabling the hot-swap hard disk drive with ServeRAID SAS/SATA controller (fixed power supply model)

The internal routing and connectors for the hot-swap hard disk drive with ServeRAID SAS/SATA controller (fixed power supply model).

The following illustrations show the internal routing and connectors for the 2.5-inch and 3.5-inch hot-swap hard disk drive models with ServeRAID SAS/SATA controller.

Note
Make sure the relevant cables pass through the cable clips.
Figure 1. 2.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
2.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
Figure 2. 2.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
2.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
Figure 3. 3.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
3.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
Figure 4. 3.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
3.5-inch hot-swap hard disk drive with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)