Skip to main content

Cabling the simple-swap hard disk drive with ServeRAID SAS/SATA controller (redundant power supply model)

The internal routing and connectors for the simple-swap hard disk drive with ServeRAID SAS/SATA controller (redundant power supply model).

The following illustrations show the internal routing and connectors for the 2.5-inch simple-swap hard disk drive models with ServeRAID SAS/SATA controller.

Note
Make sure the relevant cables pass through the cable clips.
Figure 1. Four simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
Four simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the right side)
Figure 2. Four simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
Four simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
Figure 3. Eight simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
Eight simple-swap hard disk drives with ServeRAID SAS/SATA controller cable connection (hardware RAID card inserted on the left side)
Note
Make sure you connect the mini-SAS cable connector 0 to the simple-swap hard disk drive backplate assembly 0 and the mini-SAS cable connector 1 to the simple-swap hard disk drive backplate assembly 1.