Skip to main content

Installing an adapter

Use this information to install an adapter.

The following notes describe the types of adapters that the server supports and other information that you must consider when you install an adapter:
  • To confirm that the server supports the adapter that you are installing, see the Lenovo ServerProven website.
  • Locate the documentation that comes with the adapter and follow those instructions in addition to the instructions in this section.
  • The adapter slots are on the PCI riser-card assembly. You must first remove the PCI riser-card assembly to access the adapter slots.
  • The expansion slots on the PCI riser-card assembly accommodate the various form factors of the non-hot-plug adapters as follows:
    • PCI slot 1: Dedicated to ServeRAID H1110 SAS/SATA Controller
    • PCI slot 2: Support one PCI Express Gen3 x8 half-length, full-height adapter
      Figure 1. PCI riser-card assembly
      PCI riser-card assembly

Read the safety information in Safety and Installation guidelines.

If you are installing an optional device in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To install an adapter, complete the following steps.

  1. Remove the cover (see Removing the cover).
  2. Remove the PCI riser-card assembly (see Removing the PCI riser-card assembly).
  3. Touch the static-protective package that contains the adapter to any unpainted metal surface on the server; then, remove the adapter from the package.
  4. Place the adapter, component side up, on a flat, static-protective surface and set any jumpers or switches as described by the adapter manufacturer, if necessary.
  5. Remove the expansion-slot filler from the PCI riser-card assembly and save for future use.
  6. Align the gold finger on the adapter with the connector on the PCI riser-card assembly, then, insert the adapter into the PCI riser-card assembly. Press the edge of the connector firmly into the PCI riser-card assembly. Make sure that the adapter is securely installed in the PCI riser-card assembly.
    Important
    Make sure that the U-shaped opening in the metal adapter bracket engages the tab on the expansion-slot filler.
    Figure 2. Adapter installation
    Adapter installation
  7. Install the PCI riser-card assembly (see Replacing the PCI riser-card assembly).
    Attention
    When you install an adapter, make sure that the adapter is correctly seated in the PCI riser-card assembly and that the PCI riser-card assembly is securely seated in the riser-card connector on the system board before you turn on the server. An incorrectly seated adapter might cause damage to the system board, the PCI riser-card assembly, or the adapter.

If you have other devices to install, do so now. Otherwise, go to Completing the installation.

Note
If the server is configured for RAID operation through an optional ServeRAID adapter, you might have to reconfigure your disk arrays after you install an adapter. See the ServeRAID documentation on the Lenovo ServerRAID Support CD for additional information about RAID operation and complete instructions for using ServeRAID Manager.