Skip to main content

Starting the LSI Configuration Utility program

Use this information to start the LSI Configuration Utility program.

To start the LSI Configuration Utility program, complete the following steps:

  1. Turn on the server.
    Note
    Approximately 20 to 40 seconds after the server is connected to power, the power-control button becomes active.
  2. When the prompt <F1 Setup> is displayed, press F1. If you have set an administrator password, you are prompted to type the password.
  3. Select System Settings > Adapters and UEFI drivers.
  4. Select Please refresh this page on the first visit and press Enter.
  5. Select LSIcontroller_driver_name Driver and press Enter, where controller_driver_name is the name of the SAS/SATA controller driver. For the SAS/SATA controller driver name, see the documentation that comes with your controller.
  6. To perform storage-management tasks, follow the procedures in the documentation that comes with the SAS/SATA controller.

When you have finished changing settings, press Esc to exit from the program; select Save to save the settings that you have changed.