Skip to main content

Completing the installation

Use this information to complete the installation.

To complete the installation, complete the following steps:

  1. If you removed the air baffle, reinstall it (see Replacing the air baffle).
  2. If you removed the server cover, replace it (see Replacing the cover).
  3. Install the server in the rack cabinet (see the Rack Installation Instructions that comes with the server for instructions).
  4. Reconnect the cables and power cords (see Connecting the cables).
  5. Update the server configuration (see Updating the server configuration).
  6. Slide the server back into the rack, if necessary.
  7. Start the server. Confirm that it starts correctly and recognizes the newly installed devices, and make sure that no error LEDs are lit.
  8. (Business Partners only) Complete the additional steps in Instructions for Business Partners.
  • Replacing the air baffle
    Use this information to replace the air baffle.
  • Replacing the cover
    Use this information to replace the cover.
  • Connecting the cables
    The following illustrations show the locations of the input and output connectors of the server.
  • Updating the server configuration
    When you start the server for the first time after you add or remove a device, you might receive a message that the configuration has changed. The Setup utility starts automatically so that you can save the new configuration settings.