Use this information for instructions on how to install an adapter in the full-length I/O book.
- See Installing an adapter for additional notes and information that you must consider when you install an adapter in the server.
- For more information about the full-length I/O book and the location of the connectors on the board, see Full-length I/O book.
To install an adapter full-length I/O book, complete the following steps:
- Before you begin, read Safety and Installation guidelines.
- Follow the cabling instructions, if any come with the adapter. Route the internal adapter cables before you install the adapter.
- Remove the full-length I/O book from the server (see Removing the full-length I/O book).
- Remove the I/O book cover. Slide the cover forward, then lift it off the I/O book.
- Make sure that the PCIe retention lever is in the open position.
- Remove the expansion slot cover.
- Touch the static-protective package that contains the adapter to any unpainted surface on the outside of the server; then, remove the adapter from the package.
- Insert the adapter into the connector on the board, aligning the edge connector on the adapter with the connector on the I/O book board.
- Press the edge of the connector on the adapter firmly into the connector on the board. Make sure that the adapter snaps into connector securely.
When you install an adapter, make sure that the adapter is correctly seated in the connector on the board before you turn on the server. An incorrectly seated adapter might cause damage to the board or the adapter.
- Connect the auxiliary power cable from the adapter to the board (see the following illustration for the location of the connector on the board).
- Close the PCIe retention lever to secure the adapter in place.
- Connect any cables to the adapter, if necessary.
- Reinstall the cover on the full-length I/O book.
- Reinstall the I/O book in the server.
- Perform any configuration tasks that are required for the adapter.
- Reconnect the server power cord and any cables that you removed.
- Turn on the peripheral devices and the server.
